R00t.cz DWL-900AP firmware
Vlastnosti
Readme
______________________ R00T'S FW MOD v0.1.1 ______________________ Change history: v0.1.1 [ PRIVATE BETA VERSION ] 21:49, 30. 3. 2007 (CEST)[[Uživatel:Soooc|Soooc]] + Speed choices limited again due to errors. Now supports: 1,1-2, 1-2-5.5, 1-2-5.5-11, 1-2-5.5-11-22 + When speed >=5.5 and SHORT preable is selected, PBCC is used (In AP/Client mode only if all stations can handle it) + Anti-Dupe packet filter at RX side - works in CLIENT/P2P BRIDGE It don't send same packet again on ETH interface. When running this FW on both sides of P2P link, you will get no longer get duplicate packets. v0.1.0 [ PRIVATE BETA VERSION ] 21:49, 30. 3. 2007 (CEST)[[Uživatel:Soooc|Soooc]] + Changed power settings to more power choices (0dDm-18dBm) + Fixed antenna switching (External antenna is external ant. :) + Added signal graph (you need flash 6 to view it - it's under extras tab. + Advanced speed choices: You can select what speeds are set in beacon frames and what speed is used for data. NOTE: Beacons are transmitted on LOWEST checked basic rate Control frames are ALWAYS transmitted at 2Mbps Data frames are transmitted on checked TX rate or lower rate (set by client) Signal graph description 21:49, 30. 3. 2007 (CEST)21:49, 30. 3. 2007 (CEST)21:49, 30. 3. 2007 (CEST)21:49, 30. 3. 2007 (CEST)21:49, 30. 3. 2007 (CEST)~ There are two thick lines in graph: GREEN = signal level RED = noise level This is average level per 1 second. Around these lines, there are red/green area: This is min / max value interval. Note: In client mode not only signal for you is measured. If there are stronger signal on same channel, you will get this signal level instead.
