Zobrazení zdroje stránky R00t.cz DWL-900AP firmware

==Vlastnosti==
==Readme==

<code> ______________________

  R00T'S FW MOD v0.1.1
 ______________________


 Change history:

  v0.1.1  [ PRIVATE BETA VERSION ]
 
          + Speed choices limited again due to errors. Now supports:
            1,1-2, 1-2-5.5, 1-2-5.5-11, 1-2-5.5-11-22
          + When speed >=5.5 and SHORT preable is selected, PBCC is used
            (In AP/Client mode only if all stations can handle it)
          + Anti-Dupe packet filter at RX side - works in CLIENT/P2P BRIDGE
            It don't send same packet again on ETH interface. When running
            this FW on both sides of P2P link, you will get no longer get
            duplicate packets.

  v0.1.0  [ PRIVATE BETA VERSION ]
           + Changed power settings to more power choices (0dDm-18dBm)
          + Fixed antenna switching (External antenna is external ant. :)
          + Added signal graph (you need flash 6 to view it - it's under
            extras tab.
          + Advanced speed choices: You can select what speeds are set
            in beacon frames and what speed is used for data.
            NOTE: Beacons are transmitted on LOWEST checked basic rate
                  Control frames are ALWAYS transmitted at 2Mbps
                  Data frames are transmitted on checked TX rate or
                   lower rate (set by client)




  Signal graph description
  There are two thick lines in graph:
  GREEN = signal level
  RED = noise level
  This is average level per 1 second.
 Around these lines, there are red/green area: This is
  min / max value interval.

 Note: In client mode not only signal for you is measured.
       If there are stronger signal on same channel, you
       will get this signal level instead.
</code>
==Externí odkazy==
*[http://www.r00t.cz/tmp/r00t-3.07-0.1.1.bin Oficiální mirror]
*[http://www.ok1mjo.com/all/ostatni/Dlink/DWL900APplus/r00t/0_1_1/ Mirror u -=RYS=-]